Masterflash Roof Flashing, 1/4 X 4 In.

1/4" x 4", Master Flash Roof Flashing, Slides Over Pipe, For Pitch To 40 Degrees, Uses Silicone Sealant Between Base & Surface, Easily Secures To Roof With Sheet Screws, Molds To Metal, Plastic, Etc, & Has A Non Fading EPDM Collar, Rated 200 Degrees Fahrenheit Continuous Heat, Iapmo/UPC Listed.

• Closed to 5-3/4 in. Master Flash® EPDM roof flashing
• 8 in. x 8 in. soft aluminum base for profiled metal roofs
• For any panel configuration, roof pitch or pipe location
• Molds to all types of roofing surfaces, including metal, plastic, tile and rubber membrane
• Marked cut lines allow for easy installation and customization for various pipe sizes with a sharp knife or scissors
• Slide over pipe, use silicone sealant between base and surface, then secure with sheet metal screws
• Non-fading EPDM collar provides maximum resistance to weathering caused by ozone and UV rays
• Rated to withstand 212°F continuous heat and approved for Type B installations; intermittent temperature resistance to 275°F

Descriptions are AI-generated. For accurate measurements, please call the store to confirm.